THE BEST TUNE-UP IN TOWN! 843-293-8534
PRECISION HEAT PUMP TUNE-UP BENEFITS:

Myrtle Beach Heat Pumps

OUR EXCLUSIVE PRECISION HEAT PUMP TUNE-UP PROCEDURE INCLUDES, AS NEEDED: 843-293-8534

1. Chemically clean and thoroughly wash condenser coil(s).

2. Thoroughly clean or replace standard air-filter(s).

3. Wash and level condensing unit for proper motor and bearing wear.

4. Lubricate motor and fan bearings as well as other moving parts   as necessary.

5. Clean and inspect evaporator coil and drain pan when readily   accessible.

6. Clean and inspect condensate drain lines and fittings.

7. Clean, level, and calibrate thermostat.

8. Adjust and thoroughly clean blower motor and fan assembly   as needed.

9. Inspect, tighten and test all electrical connections.  This includes disconnect switch

10. Inspect all system electrical wires, connectors, and terminals.

11.  Test system starting and running capacitors.

12.  Test all controls, switches, relays, transformers, contactors, motors, and   fans.

13. Measure starting and running amperes, line voltage, and control voltage.

14.  Test system-starting capabilities.

15.  Test system for proper airflow and air delivery.

16.  Inspect and adjust all safety controls.

17. Monitor refrigerant (Freon) pressures and temperatures.

18.  Test and record super-heat and sub-cooling. Compare with factory   specifications.

19.  Adjust Freon metering control device per factory/manufacturers recommendations.

20.  Test and measure system for proper production and capacity.

21.  Monitor fan motors and compressor operating temperatures.

22.  Apply weather resistant protective coating to the outside unit (condenser).

Myrtle Beach Heat Pump Systems

For our local climate here in the Myrtle Beach area we have moderate heating needs and a heat pump is an energy-saving alternative to furnaces found in colder climates.  As we explained in our article on air conditioners, these units act very much the same way are your refrigerator for air conditioning purposes.  A heat pump actually moves the air from the outdoors through coils which warms the air.

In this area the most used heat pump is an air-source unit which will transfer the heat from your home to the outside and back again.  Most homes in our area heat with electricity and a heat pump helps to save the amount of electricity you use for heating purposes by as much as 40%.  However, this efficiency drops in cooler climates which makes them unsuitable for colder areas.  Since we have a large population of transplants from these colder climates, many people are unfamiliar with a heat pump and how it works.

:Lower utility bills by reducing energy consumption and waste.
:Extended equipment life.
:Piece of mind for you and your family.
:Fewer repairs, and improved system reliability.
:Increased heating and cooling capacity and efficiency.

What Not To Do With A Heat Pump

We are often asked by our customers if they should turn down the thermostat during the day when they are not at home as this was a common practice with furnaces.  This will actually cause a loss in efficiency as the unit has to work longer and harder to reach the desired room temperature.  You will save money in the long run by setting it on a temperature that you can live with and putting on a sweater or blanket.

You can gain additional efficiency by installing a geothermal (also referred to as water or ground source pump) heat pump. This type of unit transfers the heat between the ground or a water source and your home.  This type of unit will cost more to install, however, they have a lower operating costs because they use a more constant ground or water temperature as opposed to the air temperature and will save money over time.  You will need to consult a heat pump professional as these units will vary depending on the subsoil, the size of your lot and landscaping.

There is a relatively new type of heat pump on the market for use in residential systems and is referred to as the absorption heat pump or a gas-fired pump.  This type of unit actually uses heat as its energy source and is usually gas driven.

Heat pumps are manufactured by a wide variety of companies.  Make sure you ask about service of the unit before you install or replace your heat pump.  Many units will require that the company that installs the unit also services the unit.  This can lead to higher than expected cost of maintenance.

  1. Complete and present full written report and make any necessary   recommendations.

Air Professionals technicians are certified in more than one type of heat pump.  Call them for installation, price comparisons or maintenance of your heat pump.

Air Professionals of Sc Inc
Myrtle Beach, SC
(843) 293-8534
airconditioningmyrtlebeach.com

Be Sociable, Share!